Arlington Automotive Machine

"I have used Eddie for the machine work for my custom rod shop for years. I was very happy until recently. 1st was a missed Crack in a SBF during magniflux that was fully machined assembled and installed in an open engine 32 model A. The "tabs" he recommended wouldn't stop the coolant leak and I had to install a crate engine to make the customer happy. 2nd a fully machined vortec block with the wrong center 3 main caps that where loose and didn't line up , but they did take the time to stamp them. Even though they weren't correct for that block. Again time and money wasted. Crate engine to make customer happy. they do good work but attention to detail is everything in the machine shop biz. You had better check the work they do before it leaves thier shop."

"Sent my SBF in to get it set up for a stroker I built and everything was on point. They know their trade and do good work."

"I brought in an intake manifold from an RB20DET that had rusty coolant puking onto it for god knows how long. Eddie gave me his recommendations on how to best clean it up and, two days later, I picked up the manifold and it was spotless. Every inch of the manifold was taken down to bare aluminum and the gasket that I had been scraping at for days was completely gone. These guys knocked it out of the park and I can't recommend them enough!"

"I have used Arlington Machine personally on the repair side for over 10 years now, and ever since we started the business in Nov 17', we use them exclusively on all of our machine work needs. Good machine shops are hard to come by, and you can tell that by visiting this place, they are always busy and loaded with work. It is 100% worth the wait, other machine shops may get it done faster, but it won't be right and you'll have to bring it back. In over 10 years, I have never had a single issue with anything I have ever picked up from Eddy and his crew at Arlington Machine. Top notch quality and work!!"

"Took my cylinder heads to this shop on a recommendation from a few guys at work. Best advice I ever got. Repair was minor but still couldn't believe the cost. About half of what I expected. Communication was great, called like he said he would. Would rate 6 stars if possible!"